Christie Digital
Touch Panel Controller (TCP) appears dead. Projector is on but cannot be controlled via TPC or net
Christie xenon cinema projectors have three separate power supplies; the lamp power supply (LPS), the low voltage power supply (LVPS) and the standby supply. The standby supply provides power to the touch panel controller (TPC) and the network ...
Christie IMB S2 Menu Missing Options
When logged into the TPC (touch panel control) with advanced credentials (ADMIN or SERVICE) as opposed to USER level authorization, the menu only presents the USER level menu options. Normal Christie IMB options when logged in as ADMIN or SERVICE ...
Picture flickering slowly on screen (Christie IMB)
A complaint was received that the picture was flickering on the screen, much like a film projector running slowly. The image did not jump abruptly between frames but rather appeared as a smooth, albeit slow, continuous motion. A review of the IMB ...
Christie Series II Projector - Programming projector to auto power cycle
These instructions apply to creating the auto power cycle ONLY if the projector is using the Christie IMB-S2. If you are using a third party IMB, follow the manufacturer's instructions for proper shutdown.
Christie - Temporary Suspension of your theatre Recommendations
The following recommendations have been provided by Christie for preparing and maintaining your projection booth for an extended shutdown. While theatres are currently suspended from operation, there are a few recommendations we suggest you take to ...
HFR 120 FPS with Christie Equipment
According to the latest information provided by Christie Digital, all Christie Series 2 and Series 3 projectors can natively support the 120FPS 2D content. As a matter of best practice the projector should be running a recent version of firmware. ...
HFR (High Frame Rate) with Christie
According to the latest information provided by Christie Digital, all Christie Series 2 and Series 3 digital cinema projectors are already capable of running 120FPS High Frame Rate without further modification and/or license. Projectors should be ...
Christie Series II Air Filters
Christie S2 Projector ICP Battery Replacement
The linked article provides instructions for changing the ICP board battery in a Christie projector
Christie Replacing the TPC (Touch Panel Controller) Battery
The linked document covers procedures for changing the battery in the Christie Touch Panel Controller
Christie TCP Battery Replacement
The attached document discusses the replacement of the battery on the Christie Touch Panel Controller (TCP). THIS IS A RISKY PROCEDURE AND SHOULD ONLY BE ATTEMPTED BY EXPERIENCED TECHNICIANS. PROCEED AT YOUR OWN RISK. Christie TCP Battery Replacement
Cannot Connect to NTP Server
This is a common error message that we receive a lot of calls on. A NTP server is a network time protocol server. Think of it as a master time clock. Your projector and/or server attempts to connect to this master time clock on a regular basis ...
Christie Automation Cues - Cinedigm Format
Christie Automation Cues - Cinedigm Format
Christie IMB - Introduction
Here's a video introduction to the Christie Digital Cinema integrated media block.
Lamp Installation Christie Digital digital cinema projector (Osram)
This video, provided by Osram, describes the lamp alignment procedure on Christie series 2 digital cinema projectors. Lamp Installation in Christie Digital (Osram) FYI - Osram lamps are available through Total Cinema Solutions.
Christie Digital Projector Lamp Change Procedure - CP2220, CP2230, CP4220, CP4230
The video linked below is provided by Christie Digital to demonstrate the lamp change procedure in the above referenced projectors. Lamp Change - CP2220, CP2230, CP4220, CP4230
Lamp Installation Christie Solaria One - Solaria One + - CP2210 - CP-2215
Here is a link to a video provided by Christie Digital that illustrates the lamp changing procedure for Solaria One/Solaria One Plus projectors. Christie Digital video for the Solaria One/One Plus
Lamp Installation Christie Digital digital cinema projector (LTI)
LTI recommends selection of the equivalent Christie lamp type rather than “Other Lamp” when installing an LTI lamp. * Average expected life is a guideline to help determine how long a lamp can be operated under optimal conditions. If the operating ...
Christie Touch Panel Controller displays Windows XP desktop
The touch panel controller (TPC) on Christie Series II projectors runs on a Windows XP Embedded operating system. The older, Series I projectors ran under a Windows CE Embedded operating system. Under normal operation, the operating system is ...